The top anchor shall be placed no lower than four (4) times the base dimension from the top of the completed scaffold. Begin ties or stabilizers when the scaffold height exceeds that dimension, and repeat at vertical intervals not greater than 26 feet. TIE CONTINUOUS (RUNNING) SCAFFOLDS TO THE WALL OR STRUCTURE at each end and at least every 30 feet of length when scaffold height exceeds the maximum allowable free standing dimension.VERTICAL AND/OR HORIZONTAL DIAGONAL BRACING MUST BE INSTALLED according to manufacturer’s recommendations.FASTEN ALL COUPLERS AND/OR CONNECTIONS securely before assembly of next level.PLUMB, LEVEL AND TIE all scaffolds as erection proceeds.POSTS SHALL BE ERECTED PLUMB in all directions, with the first level of runners and bearers positioned as close to the base as feasible.BRACING, LEVELING & PLUMBING OF TUBE & CLAMP AND SYSTEM SCAFFOLDS.All brace connections shall be made secure, in accordance with the manufacturer’s recommendations. Each frame or panel shall be braced by horizontal bracing, cross bracing, diagonal bracing or any combination thereof for securing vertical members together laterally.Do not force frames or braces to fit-level the scaffold until proper fit can easily be made. Plumb and level all scaffolds as the erection proceeds.BRACING, LEVELING & PLUMBING OF FRAME SCAFFOLDS.USE ADJUSTING SCREWS or other approved methods instead of blocking to adjust to uneven grade conditions.Any part of a building or structure used to support the scaffold shall be capable of supporting the maximum intended load to be applied. SCAFFOLD BASE MUST BE SET ON AN ADEQUATE SILL OR PAD to prevent slipping or sinking and fixed thereto where required.Guidelines for Erection and use of Scaffolds DO NOT WORK ON SCAFFOLDS if your physical condition is such that you feel dizzy or unsteady in any way.NEVER USE EQUIPMENT FOR PURPOSES OR IN WAYS FOR WHICH IT WAS NOT INTENDED.NEVER TAKE CHANCES! IF IN DOUBT REGARDING THE SAFETY OR USE OF THE SCAFFOLD, CONSULT YOUR SCAFFOLD SUPPLIER.Report any unsafe condition to your supervisor. ERECTED SCAFFOLDS SHOULD BE CONTINUALLY INSPECTED by users to be sure that they are maintained in safe condition.DO NOT ABUSE OR MISUSE THE SCAFFOLD EQUIPMENT.DO NOT ERECT, DISMANTLE OR ALTER A SCAFFOLD unless under the supervision of a qualified person.SCAFFOLDS MUST BE ERECTED IN ACCORDANCE WITH DESIGN AND/OR MANUFACTURERS’ RECOMMENDATIONS.Never use any equipment that is damaged or defective in any way. These conditions should be corrected or avoided as noted in the following sections. A survey shall be made of the job site for hazards, such as untamped earth fills, ditches, debris, high tension wires, unguarded openings, and other hazardous conditions created by other trades. FOLLOW ALL STATE, LOCAL AND FEDERAL CODES, ORDINANCES AND REGULATIONS pertaining to scaffolding.POST THESE SCAFFOLDING SAFETY GUIDELINES in a conspicuous place and be sure that all persons who erect, dismantle or use scaffolding are aware of them.If these guidelines in any way conflict with any state, local, federal or other government statute or regulation, said statute or regulation shall supersede these guidelines and it shall be the responsibility of each user to comply therewith. These guidelines do not purport to be all-inclusive nor to supplant or replace other additional safety and precautionary measures to cover usual or unusual conditions. Our product is WorkSafe certifiedĦ.Finish:Sanded faces,Arises removed by chamfering.It shall be the responsibility of all users to read and comply with the following common sense guidelines which are designed to promote safety in the erecting, dismantling and use of scaffolds. The versatile timber is available in multiple sizes to suit your needs.Īll Scaffold planks complete testing to meet Australian standard 1577. Victoria Scaffolding supplies an affordable and sustainable plank that possesses a structural integrity similar to steel. Our Timber planks use laminated veneer lumber, a process to efficiently source timber by combining multiple thin veneer sheets using industrial grade adhesive. Scaffold planks sit on Transoms and allow construction workers to access elevated working heights. Timber Scaffold Planks create an elevated work platform for Kwikstage Scaffolding. Description SCAFFOLD TIMBER PLANK, LVL TIMBER PLANK
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |